Safety trim fitting instructions 
Back to the Safetytrim page

 

1

Remove any wheelnut covers that installed on the wheel

2

Check if all the wheelnuts are torqued correctly

3

Check if all the wheelnuts are free of contaminations, like rust, paint, dirt etc.

4

Take the Safetytrim in one hand and make sure all the indicators are in the open position, the aim is that the yellow indicators aren’t visible after the installation

5

Hold the safetytrim next to the wheel, make sure that all the nuts are in alignment with the safetytrim. Press the Safety trim against the wheel. Twist the covers with minimal force to ensure a good fit. Press the Safetytrim firmly against the wheel, don’t use any tools!

The result after following the steps is a strong connection between the wheel and the Safetytrim

Back to Top